« previous next »
Pages: [1]   Go Down

Author Topic: OS max-12TZ(p) con rod.  (Read 2053 times)

0 Members and 1 Guest are viewing this topic.

Offline BCbud

  • Forum Veteran
  • ***
  • Posts: 1202
OS max-12TZ(p) con rod.
« on: May 27, 2015, 09:38:28 PM »
OK, rooky mistake. I did not pay attention as to witch way the small oiling hole was facing when I took the rod out to replace.

Thanks, Neil.

Logged
Xray T4 2013 Touring Stock - Xray T4 2013 VTA - Xray NT1 - CRC Gen-X10  - CRC GEN-X - CRC GEN-XI - Traxxas Slash 4X4 with LCG conversion - RC8Be  - Xray XB4  - DX3R-PRO
Recycled teenager.
XLR8!

Offline BCbud

  • Forum Veteran
  • ***
  • Posts: 1202
Re: OS max-12TZ(p) con rod.
« Reply #1 on: May 28, 2015, 10:09:31 AM »
After some looking, I found the answer on RC-tec.

http://www.rctech.net/forum/4811855-post2.html

Neil.
Logged
Xray T4 2013 Touring Stock - Xray T4 2013 VTA - Xray NT1 - CRC Gen-X10  - CRC GEN-X - CRC GEN-XI - Traxxas Slash 4X4 with LCG conversion - RC8Be  - Xray XB4  - DX3R-PRO
Recycled teenager.
XLR8!

Offline gotnitro

  • Forum Veteran
  • ***
  • Posts: 2006
Re: OS max-12TZ(p) con rod.
« Reply #2 on: May 28, 2015, 03:20:09 PM »
The hole is meant to lubricate the bearing. Is that what u where asking about?
Logged

Offline BCbud

  • Forum Veteran
  • ***
  • Posts: 1202
Re: OS max-12TZ(p) con rod.
« Reply #3 on: May 28, 2015, 09:33:42 PM »
Quote from: gotnitro on May 28, 2015, 03:20:09 PM
The hole is meant to lubricate the bearing. Is that what u where asking about?

Yes, I was not shure if it should face the crank or end cap but I know now that it faces the crank.

Neil.
Logged
Xray T4 2013 Touring Stock - Xray T4 2013 VTA - Xray NT1 - CRC Gen-X10  - CRC GEN-X - CRC GEN-XI - Traxxas Slash 4X4 with LCG conversion - RC8Be  - Xray XB4  - DX3R-PRO
Recycled teenager.
XLR8!
Pages: [1]   Go Up
« previous next »