Print Page - OS max-12TZ(p) con rod.

Title: OS max-12TZ(p) con rod.
Post by: BCbud on May 27, 2015, 09:38:28 PM

OK, rooky mistake. I did not pay attention as to witch way the small oiling hole was facing when I took the rod out to replace.

Thanks, Neil.

Title: Re: OS max-12TZ(p) con rod.
Post by: BCbud on May 28, 2015, 10:09:31 AM

After some looking, I found the answer on RC-tec.

http://www.rctech.net/forum/4811855-post2.html

Neil.

Title: Re: OS max-12TZ(p) con rod.
Post by: gotnitro on May 28, 2015, 03:20:09 PM

The hole is meant to lubricate the bearing. Is that what u where asking about?

Title: Re: OS max-12TZ(p) con rod.
Post by: BCbud on May 28, 2015, 09:33:42 PM

Quote from: gotnitro on May 28, 2015, 03:20:09 PM
The hole is meant to lubricate the bearing. Is that what u where asking about?

Yes, I was not shure if it should face the crank or end cap but I know now that it faces the crank.

Neil.

Island Radio Operated Car Club