OS max-12TZ(p) con rod.

[BCbud]

OK, rooky mistake. I did not pay attention as to witch way the small oiling hole was facing when I took the rod out to replace.

Thanks, Neil.

[BCbud]

After some looking, I found the answer on RC-tec.

http://www.rctech.net/forum/4811855-post2.html

Neil.

[gotnitro]

The hole is meant to lubricate the bearing. Is that what u where asking about?

[BCbud]

The hole is meant to lubricate the bearing. Is that what u where asking about?

Yes, I was not shure if it should face the crank or end cap but I know now that it faces the crank.

Neil.