roll out?

[gotnitro]

hey what is a good roll out and will 64 pitch handle the torque. what spur is a good size

[Gorden]

hey what is a good roll out and will 64 pitch handle the torque. what spur is a good size

At the big chill they were using 88t and I'm not sure but I think the roll out for there was around 80
if you don't have any I have a few extra 88t spurs left @ $5.50 each

[gotnitro]

hey gord that booster does it go in the servos or esc port on the reciever

[Blake]

I ran a rollout of 70mm at our track last weekend during the practice sessions.  My car was pretty similar to Craig's for speed/acceleration.  My ESC was setup exactly the same as my 12th Scale ESC setup.

Blake

[BCbud]

Good day!

The plug of the booster usually will go in the bind or aux port in the Rx. You will need to use a plug or solder some wires on the + and - pins on the other end. These wires will need to be solderd to the + and - battery posts on the speedo.

Neil

[Gorden]

hey gord that booster does it go in the servos or esc port on the reciever

I have mine in the bind plug on my receiver so the bat or aux plug

[gotnitro]

so i need to take a wire from esc to the reciever to this plug its the mpn booster

[gotnitro]

blake r u running 64p

[Blake]

Yes, 64p.

Blake

[gotnitro]

ok thanks

[BCbud]

so i need to take a wire from esc to the reciever to this plug its the mpn booster

The booster plug will go into a spair slot on your radio. There are 3 pins on the other side of the booser oposite of the plug end. one is +, one is - and one is a pass through that will not be used. You need to supply direct from the battery Pos and Neg to the + and - pins on the booster. The easyest way to tap into the battery power is to conect wires to the posts on the esc where the battery plug is conected. You can use an extra reciever plug to conect the wires to the booster or solder them right to the pins and shrink wrap them.

[gotnitro]

got it neil thanks

[Gorden]

so i need to take a wire from esc to the reciever to this plug its the mpn booster

this photo might help as you can see I'm getting the power for the booster from the bat - & + plugs
the white is not hooked up

[gotnitro]

yes all in had to double check before i turn it on.

[Falcon]

Cut the white off